Skip to content

Gas Leak Detection Abermain

Gas leak detection in Abermain means a licensed gas fitter finding where gas escapes from your household pipework and repairing it. You need it for any smell of gas, a lazy flame or a meter dial turning with every appliance off. We test, locate and quote first, so ring (02) 4063 3475.

More gas work. The gas fitting hub covers the wider gas work, and the plumber in Abermain home page lists everything else we do.

Licensed plumbers and gas fitters · NSW Lic. 359278C

Last updated September 2026

Gas fitter at work on a kitchen oven

What Should You Do First?

A strong smell inside the house is a get-out-now moment, and the repair can wait until everyone is clear.

  • Walk out with the family and pets and stay out in the yard or on the street.
  • Leave light switches, the stove and power points untouched, and make no calls from inside.
  • If you pass the meter and its valve is easy to turn, shut it on the way.
  • From outside, ring the distributor's emergency number, then call us for the repair on your pipework.

A smell that comes and goes near a heater still needs a fitter. A small leak can be slow for weeks before it gets worse.

Gas cooktop burner alight
Plumber beside a newly installed continuous-flow gas hot water unit

How Do You Know Gas Is Escaping?

Signs that point to a leak in household pipe or fittings:

  • A rotten-egg odour near the stove, a wall heater or the meter box.
  • Cooktop burners that flicker yellow where they should burn a clean blue.
  • A faint whistle or hiss at a joint when the appliances are all off.
  • Feeling light-headed indoors and better once you step outside.

Any one of these calls for a licensed fitter with test gear, not a sniff test.

How We Trace and Repair It

  1. 01

    Shut off and gauge

    The supply is closed at the meter, a gauge goes on the line, and a falling reading confirms gas is getting out.

  2. 02

    Follow the pipe

    An electronic gas detector is moved along every exposed joint between the meter and each appliance until the reading peaks.

  3. 03

    Uncover the fault only

    We open just the section that failed, such as a cracked flare fitting behind a heater or unsleeved pipe rubbing on a stud.

  4. 04

    Fix and prove it

    The new fitting or pipe goes in, the gauge holds steady for the test period, and each appliance is relit and checked.

What Sets the Price of a Leak Repair?

The cost of a gas repair turns on:

  • How deep the leak is buried, since a joint at the cooktop is quicker to reach than pipe under the floorboards.
  • What sits in the way, such as an old built-in heater that must come off the wall.
  • How much needs replacing, from a single fitting to several metres of old pipe.
  • When you need us, as night and weekend work costs more.

Gas Added to Old Cottages

Every conversion was its own job

Abermain's weatherboard and fibro cottages were built as a coal village in the early 1900s, before gas was part of the plan, and each home was connected later on its own timeline. That can leave older fittings and pipe passing through walls without a sleeve behind stoves and heaters.

One test covers the whole run

After the leak is sealed, the pressure test takes in every metre from the meter to each appliance, so a second weak joint shows up on the same visit. If the fault is inside the cooktop or heater and not the pipe, installing a new gas appliance is the next step.

When We're Not the Right Call

A leaking meter or a fault in the gas main under the street is repaired by the gas distributor, so their emergency line comes before ours. A burner control failing inside a heater under its own warranty is a job for that brand's service agent, once we have shown the supply pipe holds pressure.

What Customers Say

We had an urgent gas problem that required immediate attention at our home…on a Friday afternoon. … Identified the issue, fixed and tested
Lee

Gas Leak Questions

Does every gas leak have a smell?

Not always. The added odour is strong, yet a tiny weep behind a wall heater can go unnoticed for months. A gauge that will not hold steady during a pressure test is the proof, smell or no smell.

Can you find the leak without pulling my stove or heater apart?

Yes. The gauge tells us the pipe is losing gas before anything is moved, and the detector points to the joint. Only the bad fitting or length of pipe is uncovered, so a cottage kitchen stays in one piece.

Whose job is a leak near the meter?

A leak in the meter or the supply pipe coming in from the street is for the gas distributor to repair. From the outlet of the meter to your appliances, the pipe belongs to the home owner, and that is the section a licensed fitter can trace and fix.

Do you come out for gas leaks after hours?

Yes. The phone is answered at night and on weekends, and a smell of gas should not sit until morning. Get outside first, then ring (02) 4063 3475 from the footpath, and you hear the night rate before we set off.

Need a plumber? Call or send the form

Call (02) 4063 3475 or send the form below. Available 24/7, you see a fixed figure ahead of any work, and every job carries our 365-day warranty on all work.

Call (02) 4063 3475

Request a callback

Leave a name and number and a plumber will ring you back.

We use your details only to call you back about this job. See our privacy policy.

Call (02) 4063 3475 Get a quote